Door frame automatic forming machine

Hydraulic Door frame forming machine

Technological process and performance parameters

Machine component: conveying frame- opening planer-servo combined punching-door frame roll rolling forming-hydraulic breaking - collecting table.

Equipment configuration and technical parameters

Supporting material shelf is vertical structure

Single head manual expanding core support material shelf

Supporting material shelf dimension not smaller than 1200mm

Supporting material shelf dimension inner diameter 400-550mm

It can satisfy the change of material width between 200mm-350mm.

Single head bearing weight not less than 3000KG

No power drive with brake

Decoiler  machine

Dimension length 1000mm * width 1500mm * centrality High 900mm

Number of opening rollers up 5 and 6

Opening rollers diameter 61mm

Opening rollers material40Cr ,tempering treatment (5) opening machine wall panel thick 28mm ,material A3 board, integral adjustment

Adjustable servo combined punching machine

10- position CNC hydraulic cylinder   Tonnage 40T

Input power:11KW；

Hydraulic system maximum working pressure 25MPa

Frequency: 10-12 times/min；

Vertical plate thickness: 70mm；

Equipment throat opening height: according to requirements;

Machine size:3000*950*1800（mm）

Door frame forming part  

1. Feed material frame

Feeding material width 400-500mm (adjust according to door frame material), material 1.2 mm-2.0 mm, band steel material Q 195, cold rolled plate, hot rolling plate.

Guide plate material cr12  Heat treatment 58-60 degrees rake construction

Equipment structure: molding main case type structure, joint location the main frame material is welded with 100mm*100mm square tube, and the machine frame is welded with 25mm steel plate.

Transmission: bevel gear transmission

Number of rolling wheel groups: group one. Roller shaft diameter 50mm (medium carbon steel). Conditioning and tempering grinder treatment.

Wheel material: made of 42crmo material, grinder treatment and die match

Rolling wheel heat treatment: hrc52-55

Surface polishing treatment of rolling wheel

Frame structure: adopt contiguous memorial archway, the thickness of memorial archway is 30mm (processed 28mm) (material A3 board), the width of the machine door is 450 mm.

Wheel forming speed: 6-8 m / min, motor press _ kw.

Tonnage of machines: 12 tons (32 groups)

Hydraulic cutting machine

The bottom frame of the hydraulic cutting machine, the middle frame is the waste stop cutting step, the cutter can be quickly replaced, the center height and the vertical and horizontal direction of the cutter can be adjusted, and the continuous cutting can be realized.

Hydraulic station power 4 kW 100 mm hydraulic cylinder, hydraulic station oil tank capacity 1 cubic.

cutting mould material Cr12mov，HRC58-62.

positive or negative cutting accuracy

The discharging frame is a frame structure, which consists of a frame and a transmission roll, which can meet the requirements of the finished product.

Electrical control device   

Simen high performance PLC components, AC servo driver, touch screen, frequency converter and other controllers are used in the equipment configuration to meet the high quality requirements of the equipment.